The DAL plugin-based virtualcamera shares data between OBS and the
plugin using an IOSurface. IOSurface locks are necessary to ensure
race conditions between data generation (OBS side) and consumption
(virtual camera side) and also that an IOSurface is not offloaded to
GPU memory when it is indeed needed in CPU memory.
Also moves the invalidation of the NSMachPort for the frames to after
the IOSurface data has been converted into a pixelbuffer and added to
the frame queue of the virtual camera, as an early invalidation will
cut off access to the pixel data shared with the DAL plugin.
Now uses GetIfEntry2 which supports 64-bit values for reporting speed, so
10+ gbps adapters are now reported correctly in the log. Also added an
additional log line if the interface error counters are non-zero to possibly
help identify physical faults. Finally the transmit and receive speeds are
logged independently so that asynchronous mediums such as Wi-Fi that might
have good RX but poor TX can be better diagnosed.
Remove code forcing x264 and ffmpeg aac encoder. People using custom
ffmpeg output should be able to use other video and audio encoders when
streaming with RTMP, given its h264 or aac.
This fixes a bug reported by R1ch internally.
If someone uses NVIDIA noise suppression filter and later uninstalls
the SDK, there can be a crash because the filter tries to load the
models.
Signed-off-by: pkv <pkv@obsproject.com>
Whe using a software renderer there will be no formats available for
using with dmabufs. We should only consider those formats wrt. to
modifiers and as such move this check after adding general support for
that format.
fixes#7985
If the display wasn't found, the timer was not reset, causing the code
to execute on every single tick, stalling the graphics thread and using
excessive CPU.
On systems with multiple graphics adapters, one card can be configured
as power saving, and another card can be configured as performance.
Sometimes, OBS and the encoder test subprocesses will not be configured
the same way, so it's necessary to provide adapter order to the encoder
test subprocesses.
This change ensures the adapter order by passing the LUIDs to the test
subprocesses. The adapter indexes will then be updated accordingly.
This call will fail on multi-adapter systems, and isn't used anyway, so
just remove it. Not sure why it was called in the first place; pretty
sure it was unintended and was likely just copied over from the D3D11
subsystem code.
This fixes a bug where the upward compressor would hard limit above the
threshold.
Also this changes detection to RMS instead of peak for the upward
compressor.
This sounds better than peak (tested on regular mike and a test tone).
Signed-off-by: pkv <pkv@obsproject.com>
Fixes#7848
Currently OBS_OUTPUT_INVALID_STREAM is emitted when a wrong password is
used. This commit expands the signal emission to case of timeouts.
Signed-off-by: pkv <pkv@obsproject.com>
When this detection helper was originally written, it incorrectly set
the hardware implementation value. This fixes it to use the correct one
based upon the index.
Neither the mfxExtMasteringDisplayColourVolumme and
mfxExtContentLightLevelInfo structures appear to be supported when using
AV1, so if using AV1, do not include these structures.
It's unknown as to why AV1 fails to initialize when using either of
these extended structures as part of its configuration parameters.
Either they're completely unsupported or there's a member variable that
causes initialization to fail.
